TM 5-1940-322-24
0127 00
ELECTRIC BILGE PUMP, BRACKET, AND FLOAT REPLACEMENT (AFT) (Contd)
NOTE
Tag all wires during removal to assist with installation.
REMOVAL
1.
Disconnect lead wires (1) and (11) from bilge pump (2) and bilge pump float (10).
2.
Remove clamp (3) and disconnect hose (4) from bilge pump (2).
3.
Remove two screws (17), four washers (15), two locknuts (14), and bilge pump and float bracket
assembly from boat (13). Discard locknuts (14).
4.
Remove two screws (8), washers (9), locknuts (12), and float (10) from bracket (16). Discard locknuts (12).
5.
Remove bilge pump (2) from bilge pump strainer (7) on bracket (16) by releasing clips (18).
6.
Remove four screws (5), four washers (6), and bilge pump strainer (7) from bracket (16).
INSTALLATION
1.
Install bilge pump strainer (7) on bracket (16) with four screws (5) and washers (6).
2.
Install bilge pump (2) on bilge pump strainer (7). Ensure clips (18) are seated.
3.
Install float (10) on bracket (16) with two screws (8), four washers (9), and two new locknuts (12).
4.
Install bilge pump and float bracket assembly on boat (13) with two screws (17), four washers (15),
and two new locknuts (14).
5.
Install hose (4) on bilge pump (2) with clamp (3). Tighten clamp (3).
6.
Connect lead wires (1) and (11) to bilge pump (2) and bilge pump float (10).
7.
Close hydrojet hatches (TM 5-1940-322-10).
8.
Connect battery ground cables (WP 0054 00).
9.
Test bilge pump and float, ensure light illuminates on instrument panel (TM 5-1940-322-10).
10.
Close battery hatch (TM 5-1940-322-10).
0127 00-2
