TM 5-1940-322-24
0142 00
HYDROJET ASSEMBLY MAINTENANCE (Contd)
REMOVAL (Contd)
8.
Remove twelve locknuts (8), washers (7), screws (4), washers (5), insulator washers (6), transom
flange (3), and gasket (2) from transom (1). Discard gasket (2) and locknuts (8).
9.
Support intake grill (13) and remove four locknuts (11), washers (12), and intake grill (13) from
studs (9) on bottom of hydrojet housing (10). Discard locknuts (11).
10.
Install lifting strap around hydrojet housing (10) and connect to suitable lifting device.
11.
Remove twenty-six locknuts (15) and washers (16) from studs (17) on hydrojet base plate (18). Discard
locknuts (15).
12.
Disconnect one end of drain down hose (19) and move hose (19) out of way.
13.
Loosen silicone rubber adhesive between hydrojet housing (10) and hydrojet base plate (18) before
lifting hydrojet assembly (14) from hydrojet base plate (18).
14.
Slowly lift hydrojet assembly (14) off hydrojet base plate (18) and studs (17) tilting as necessary to
clear studs (17) and slowly moving forward to remove hydrojet steering deflector (20) from opening in
transom (1).
NOTE
It may be necessary to rest hydrojet assembly on blocks or support
braces to readjust lifting strap before lifting hydrojet assembly
from boat.
15.
Lift and tilt hydrojet assembly (14) as necessary to remove from boat.
1
9
~
2
10
13
3
8
7
12
11
6
4
5
0142 00-4
