TM 5-2090-200-12&P (2) Remove pins (8-12 and 42) and remove cables (7, 11 and 45). (3) Refer to figure 4-2 and remove cable lashing assemblies. b. Cleaning, inspection and repair. (1) Inspect   all   cables   for   wear,   breaks,   and   damage.      Inspect   for   missing,   worn   or   damaged hardware. WARNING Dry  cleaning  solvent,  P-D-680,  used  to  clean  parts  is  potentially  dangerous  to  personnel  and property.  Avoid  repeated and prolonged skin contact.  Do not use near open flame or excessive heat.  Flash point of solvent is 100°  F. - 1380 F. (38°  C. - 59°  C.). (2) Clean cables and hardware with dry cleaning solvent (Fed. Spec P-D-680). (3) Replace any damaged or worn cables.  Replace missing or damaged hardware. c. Installation. (1) Install cables (1, 7, 11 and 45) and secure with pins (2, 8, 12 and 42). (2) Refer to figure 4-2 and install cable lashing assemblies. Key to figure 4-1 1 Tie down cable 24 Access cover 2 Pin 25 Capscrew 3 Wire rope 26 Lockwasher 4 Sleeve 27 Washer 5 Shackle 28 Shackle 6 Hook 29 Shackle 7 Tie down cable 30 Pin 8 Pin 31 Wire rope 9 Wire rope 32 Sleeve 10 Sleeve 33 Cradle stanchion 11 Tie down cable 34 Boat guide stanchion 12 Pin 35 Pin 13 Wire rope 36 Wire rope 14 Sleeve 37 Sleeve 15 Pin 38 Nut 16 Washer 39 Nut 17 Cotter pin 40 Shackle 18 Shackle 41 Rope 19 Screw pin shackle 42 Pin 20 Lashing cable 43 Wire rope 21 Lashing cable 44 Sleeve 22 Identification plate 45 Cable 23 Rivet Change 2 4-4