TM 5-2090-200-12&PSection III. TROUBLESHOOTING3-5. Generala.This section contains troubleshooting information for locating and correcting troubles whichdevelop in the boat cradle. Each malfunction for an individual component, unit, or system is followed by a list oftests or inspections which will help you to determine probable causes and corrective actions to take. Youshould perform the tests, inspections, and corrective actions in the order listed.b.This manual cannot list all malfunctions that may occur, nor all tests or inspections andcorrective actions. If a malfunction is not listed or is not corrected by listed corrective actions, notify yoursupervisor.3-6. Operator/ Crew Maintenance TroubleshootingFor operator/crew maintenance troubleshooting, refer to table 3-2.Table 3-2. TroubleshootingMALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1.DOLLY BINDS OR WILL NOT TRAVELStep 1.Check for released latch hook.Pull push-pull cable T-handle to release latch hook .Step 2.Check the tie-down cable assemblies to see if they are connected.Remove tie-down cable assemblies.a. Grasp the turnbuckle handle and turn in a counterclockwise direction until cable is loose.b.Pull tie hook up and free of the top edge of dolly .c.Remove the cable assembly.2.LATCH RELEASES OR FAILS TO ENGAGEStep 1.Check for debris in latching mechanism.Remove debris.Use a stiff brush or pointed tool and remove debris between the hook latch and link or link clevis.Step 2.Check if latch hook is engaged to the latch block.Re-engage the latch.Push the push-pull cable T-handle in, into engaged position.3-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
