TM 5-5420-202 -20-2
LEFT OUTER AND INNER ENGINE-TO-TRANSMISSION OIL LINE TUBE ASSEMBLIES
REPLACEMENT (Sheet 2 of 4)
NOTE
Place rags or drip pan under fittings (H & A and K & C).
Before removing tubes and fittings, seal powerplant
openings with plastic barrier material and masking tape to
prevent unnecessary
exposure to moisture and
Remove plastic barrier material and
masking tape when installing tubes and fittings.
REMOVAL:
1.
Using 1-5/8 inch wrench to hold adapter (A), use 1-1/2 inch wrench and loosen connector
(B).
2.
Using 1-5/8 inch wrench to hold adapter (C), use 1-1/2 inch wrench and loosen connector (D).
3.
Using hands disconnect and remove tube (E) from powerplant.
Using 1-5/8 inch wrench, remove adapters (A and C) and gaskets (F and G). Throw gaskets
4.
away.
5.
Using 1-5/8 inch wrench to hold adapter (H), use 1-1/2 inch wrench and loosen connector (J).
6.
Using 1-5/8 inch wrench to hold adapter (K), use 1-1/2 inch wrench and loosen connector (L).
7.
Using hands disconnect and remove tube (M) from powerplant.
8.
Using 1-5/8 inch wrench, remove adapters (H and K) and gaskets (N and P). Throw gaskets
away.
Go on to Sheet 3
6-69