TM 5-5420-202-20-2
FUEL LINE INSULATOR REPLACEMENT (Sheet 1 of 10)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS: 1/2 in combination box and open end wrench (2 required)
1/2 in. socket with 3/8 in. drive
5 in. extension with 3/8 in. drive
Ratchet with 3/8 in. drive
Torque wrench with 3/8 in. drive (0-200 lb-in) (0-23 N m)
SPECIAL TOOLS:
1/2 in. crowfoot wrench with 3/8 in. drive
P R E L I M I N A R Y PROCEDURES:
Remove top deck (page 16-21)
Remove powerplant (page 5-2)
Remove cooling fan shroud (page 9-47)
Remove engine access cover (right bank) (page 6-107)
Remove engine access cover (left bank) (page 6-1 12)
REMOVAL:
1.
Using two 1/2 inch wrenches, remove two bolts (A) and nuts (B) holding insulators (C)
and plate (D) to support (E). Remove insulators (C) and plate (D).
2.
Using two 1/2 inch wrenches, remove insulators and plate from support (F), (G), (H), (J),
and (K), same as step 1 above.
Go on to Sheet 2