TM 5-5420-202-20-2
MANIFOLD HEATER FUEL FILTER AND INPUT FUEL LINE REPLACEMENT (Sheet 8 of 8)
Fuel Filter Input Fuel Line Replacement (Sheet 1 of 1)
TOOLS: 1/2 in. open end wrench
5/8 in. open end wrench
SUPPLIES: Clean bucket or drip pan
REFERENCE:
Remove engine access covers (pages 17-11 and 17-13)
PRELIMINARY PROCEDURE:
REMOVAL:
CAUTION
When removing or installing fuel lines care must be taken
not to damage fittings and threads or twist or distort fuel
lines or hoses.
NOTE
Use a suitable container to catch any fuel that may leak out
wherever any part of the fuel system is loosened or
disconnected.
Using 1/2 inch and 5/8 inch open end wrenches, disconnect both ends of tube assembly
1.
(A) from adapters (B and C).
2..
Remove tube assembly (A).
INSTALLATION:
1.
Position tube assembly (A) to adapter (B and C).
2. Using 1/2 inch and 5/8 inch open end wrench, install tube assembly to adapters.
operate purge pump (TM 5-5420-202-10) and check for leaks. If leak is found, tighten
3.
connection as required.
Install engine access covers (pages 17-12 and 17-14).
4.
TA248376
End of Task