TM
5-5420-202-20-2
RIGHT EXHAUST EJECTOR TUBE REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
1.
Position insulation (A and B) to ejector
tube (C).
2.
Using cross-tip screwdriver and 5/16 inch
wrench, install 11 screws (D), 22 flat
washers (E), 11 new lockwashers (F), and
11 nuts (G) to secure insulators (A and B)
to ejector tube (C).
3.
Position packing (H) and clamp (J) onto
e j e c t o r tube (C). Use flat-tip screwdriver
to tighten clamp (J).
4.
Apply coating of silicone compound
to end of hose (K).
Position right exhaust ejector tube (C)
5.
and new gasket (L) onto studs of turbo-
supercharger (M) and hose (K).
6.
Using 9/16 inch wrench, install six new
self-locking nuts (N) to secure right ex-
h a u s t ejector tube (C) to turbosuper-
charger (M).
Go on to Sheet 4
Change 1