TM
5-5420-202-20-2
LEFT EXHAUST EJECKTOR TUBE REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
1.
Position insulation (A and B) to ejector
tube (C).
Using cross-tip screwdriver and 5/16 inch
2.
wrench, install 11 screws (D), 22 flat
washers (E), 11 new lockwashers (F), and
11 nuts (G) to secure insulation (A and B)
to ejector tube (C).
Position packing (H) and clamp (J) onto
3.
e j e c t o r tube (C). Use flat-tip screwdriver
to tighten clamp (J).
4.
Apply a light coat of silicone compound
to end of two hoses(K).
Position left exhaust ejector tube (C) and
5.
new gasket (L) onto studs of t u r b o s u p e r -
charger housing (M).
Using 9/16 inch wrench, install six new
6.
self-locking nuts (N) to secure left ex-
haust ejector tube (C) to turbosuper-
charger housing (M).
Go on to Sheet 4
Change 1