TM 5-5420-202-20-3
ENGINE GENERATOR REPLACEMENT (Sheet 5 of 8)
INSTALLATION:
1.
Make sure wooden blocks are positioned under right manifold heater.
WARNING
Generator (A) weighs approximately 100
pounds. Injury to personnel or damage to
equipment could result through careless
handling.
2.
Using two technicians, place generator (A) on wood blocks.
3.
Install six nuts (B) to drive adapter (C). Do not tighten nuts (B).
4.
Install three boot clamps (D) to boot (E).
NOTE
Apply silicone compound to the inside of
the generator boot sealing surfaces before
installation.
5.
Install assembled boot (F) to generator (A).
6.
Using two technicians, aline generator flange
(G) to six nuts (B). Rotate generator (A)
clockwise and push flange (G) onto six nuts
(B).
TA248951
Go on to Sheet 6