TM 5-5420-202-20-3
STARTER REPLACEMENT (Sheet 4 of 7)
NOTE
The top and front fasteners have bolts (AA)
which pass through the engine hull housing
(AB) and must be held in place when removing
the self-locking nuts (AC). The inboard
fastener has a stud and will not require a
wrench to hold it in place.
11. Using 15/16-inch wrench on bolts (AA) and
special wrench on self-locking nuts (AC)
loosen and remove three self-locking nuts
(AC) securing starter (G) to starter drive
adapter (AD).
12. Using two people, ease starter out of starter drive adapter (AD).
Remove starter from engine.
13. Remove gasket (AE) from starter drive adapter (AD). Throw away gasket.
TA248965
Go on to Sheet 5
10-24