TM 5-5420-202-20-3
STARTER REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
15/16 in. combination box and
TOOLS
Ratchet with 1/2 in. drive
open end wrench
10 in. extension with 1/2 in. drive
Diagonal cutting pliers
1/2 in. socket with 1/2 in. drive
Flat-tip screwdriver
9/16 in. socket with 1/2 in. drive
Torque wrench with 3/8 in. drive
3/4 in. socket with 1/2 in. drive
1/2 in. combination box and
(0-200 lb-in.)
3/4 in. socket with 3/8 in. drive
open end wrench
Slip joint pliers
3/4 in. combination box and
open end wrench
SPECIAL TOOLS: Ground hop kit (Item 31, Chapter 3, Section I)
Wrench, fixed, open end (Item 3, Chapter 3, Section I)
Pencil (Item 71, Appendix D)
SUPPLIES
Seven tags
Lockwire (10 in.) (Item 61, Appendix D)
Glyptol (Item 39, Appendix D)
Gasket
Lockwashers (8 required)
Two
PERSONNEL:
REFERENCES: TM 5-5420-202-10
Remove powerplant (page 5-2)
PRELIMINARY PROCEDURES:
Remove starter low voltage relay
solenoid (page 10-227)
TA248962
Go on to Sheet 2