TM 5-5420-202-20-3
BASKET/CONTROL PANEL POWER HARNESS REPLACEMENT (Sheet 2 of 4)
2.
Disconnect connector (C) at basket disconnect
Using 7/16 inch socket, remove top screw
3.
(D), lockwasher (E), and flat washer (F)
securing strap (G) at three locations.
Leave bottom screw (H) installed.
4.
Using 7/16 inch socket, remove screw
(J) and lockwasher (K) securing clamp
(L) at six locations.
5.
Using fingers, slip basket/control panel
power wiring harness (M) from behind straps
(G), out of clamps (L), and remove from
vehicle.
NOTE
The illustration below shows the
assembly
l o c a t i o n of
harness
supporting clamps and straps and
the routing of the harness assembly.
Go on to Sheet 3
15--28 6.26
0 29
Change 7