TM 5-5420-202-20-3
BASKET/CONTROL PANEL HEATER HARNESS REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
1.
Position wiring harness in vehicle.
2.
Position wiring harness in three straps
(A) and six clamps (B).
3.
Using 7/16 inch socket, install screws
(C), new lockwashers (D), and flat washers
(E) to secure harness assembly to over-
head crossbeam (F) at three locations.
NOTE
This illustration shows general
routing of the harness assembly
and the location of supporting
straps and clamps.
Using 7/16 inch socket, install screws (G) and new lockwashers (H) to secure harness
4.
assembly at six locations.
Go on to Sheet 4
Change 7