TM 5-5420-202-20-3
FRONT ACCESSORY HARNESS REPLACEMENT (Sheet 8 of 14)
INSTALLATION:
NOTE
Lubricate rubber-to-rubber contact surfaces at assembly
of waterproof connectors with silicone compound (Item 10,
Appendix B).
Note that each lead has a circuit number marker attached
to it.
Mate each connector to its mating connector,
identified by the marker.
Position wiring harness (A) in vehicle.
1.
2.
Using adjustable wrench to hold flange
(B) of reverse polarity protection device
and 7/8 inch wrench on connector (C),
connect connector (C) (CKT 459A)
to reverse polarity protection device
on master relay.
3. Connect connector (D) (CKT 415A, 478
and 2) to voltage regulator (E). Using
spanner wrench, tighten connector (D).
Go on to Sheet 9
5-90