TM 5-5420-202-20-3
BRAKE MASTER CYLINDER REPLACEMENT (Sheet 6 of 9)
INSTALLATION:
1.
Using 1-1/8 inch socket, remove filler
cap (A) from master cylinder (B).
CAUTION
Look inside the master cylinder (B)
through the filler cap hole (C) to the
bottom. The hole arrangement must
look like the pattern of holes shown
in (D). If not, install filler cap (A),
get the correct one, then repeat step 1
above.
2. Get master cylinder ready for installation by removing all packing material, pipe plugs,
or plastic caps from ports (E) if installed. Clean as needed.
Using fingers, install filler cap (A) to master cylinder (B) finger tight.
3.
Using 3/4 inch wrench, remove drain plug (F) and gasket (G) and relocate and install
4.
at forward port (H).
Go on to Sheet 7
TA249397