TM 5-5420-202-20-3
BRAKE LEFT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 4)
CLEANING AND INSPECTION:
WARNING
To prevent personal injury, wear
Dry cleaning solvent P-D-680 is toxic and flammable.
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
1.
Clean all metallic parts in dry cleaning
solvent.
Inspect all parts for damage or wear.
2.
Replace all unserviceable parts.
3.
Inspect tube assembly nut for cracks.
Replace tube assembly if any cracks
are found.
INSTALLATION:
1.
Insert new packing (A) in groove of
slave cylinder (B).
Position and slide slave cylinder (B)
2.
down over housing assembly push rod (C).
Wiggle it back and forth while pushing
down. Push slave cylinder (B) forward
when on housing assembly (D), then
pull back to make sure catch (E) engages
in housing assembly (D).
Tighten mounting nut (F) to stud (G)
3.
finger tight.
4.
Using 9/16 inch socket, tighten mounting
nut (F).
Go on to Sheet 4
