TM 5-5420-202-20-3
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 2 of 6)
Position container under tube (A) and
1.
tee (B) to catch brake fluid.
Using 11/16 inch wrench, disconnect
2.
nut of tube assembly (A) from tee (B).
NOTE
Allow brake fluid to drain.
of fluid in accordance with
cedures.
3.
Using 7/16 inch socket, remove screw
(C), lockwasher (D), and clamp (E).
Using 13/16 inch box wrench, loosen
4.
bolt (F) from slave cylinder.
Remove bolt (F), tube (A), and two gaskets
5.
(G) as an assembly from slave cylinder (H).
Throw gaskets (G) away.
6. Installl plastic cap on tee (B).
Install plastic plug in nut of tube assembly
7.
(A) and masking tape on parts in other
end.
Using 9/16 inch socket, remove screw
8.
(J), lockwasher (K), and bracket (L).
NOTE
Replace screw (J) and lockwasher (K) to hold adjusting screw lock plate in
place until installation of bracket (L).
T A2 4 9 4 4 4
Go on to Sheet 3
13-59