TM 5-5420-202-20-3
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 5 of 6)
8.
Remove plastic cap from tee (F) and plastic plug and masking tape from tube assembly
(G).
9.
Thread nut of tube assembly (G) on tee (F) finger tight.
10.
Position two new gaskets (H), bolt (J), and end of tube assembly (G) as an assembly
over hole in slave cylinder (B).
11.
Insert bolt (J) and tighten finger tight.
12.
Using 13/16 inch wrench, tighten bolt (J).
13.
Using 11/16 inch wrench, tighten nut of tube assembly (G) to tee (F).
14.
Place clamp (K) over tube assembly (G) and position clamp on bracket (E).
15.
Place lockwasher (L) on screw (M) and insert through clamp (K) and bracket (E). Tighten
finger tight.
16.
Using 7/16 inch socket, tighten screw (M).
Go on to Sheet 6
13-62