TM 5-5420-202-20-3
TRACK SUPPORT ROLLER WHEEL AND HUB REPAIR (Sheet 2 of 5)
NOTE
If special tools do not fit into hub,
stop work and order a complete
new support roller assembly, then
install support roller on vehicle
2.
Position remover-replacer to inside
of inner wheel hub cup (B).
Screw handle into remover-replacer from
3.
other side of hub (C).
4.
Using hammer, tap handle to drive inner bearing cup (B) out of hub. Remove cup.
Position bearing inserter set to inner edge of
5.
outer bearing cup (C).
Screw handle into bearing inserter set on
other side of hub (C).
Using hammer, tap handle to drive outer
bearing cup (D) from hub (C). Remove cup.
Go on to Sheet 3
14-46
Change 4