TM 5-5420-202-20-3
SHOCK ABSORBER MOUNTING YOKE BUSHING REPLACEMENT (Sheet 2 of 4)
Front and Middle Mounting Yoke Bushings Replacement (Sheet 2 of 2)
5. Position remover and replacer (C) on
forward bushing (F) of mounting yoke (B).
6. Position handle (E) through mounting yoke
(B) on remover and replacer (C) and, using
hammer, drive bushing (F) out of mounting
yoke (B).
INSTALLATION:
1.
Position forward bushing (A) on remover
and replacer (B) and aline bushing (A) in
mounting yoke (C).
Position handle (D) through mounting yoke
2.
(C) on remover and replacer (B) and, using
hammer, drive bushing (A) into mounting
yoke (C) until flush with surface.
Remove handle (D) and remover and
3.
replacer (B).
Position rear bushing (E) on remover and
4.
replacer (B) and aline bushing (E) with
mounting yoke (C).
Position handle (D) on remover and replacer
5.
and, using hammer, drive bushing (E) into
mounting yoke (C) until flush with surface.
NOTE
If middle mounting yoke bushing was replaced, go to step
6. If not, go to step 7.
Install two track center guides (TM 5-5420-202-10).
6.
Install shock absorber (page 14-96).
7.
End of Task
Change 4
14-98.2