TM 5-5420-202-20-4
REAR DRAIN VALVE CONTROL LEVER ASSEMBLY REPLACEMENT (Sheet 4 of 4)
Clamp bracket (B) in vise.
5.
Using 1/8 inch punch and pliers, line up hole in shaft (A) with hole in control lever (C).
6.
Using pliers, start pin (D) in hole in control lever (C).
7.
Using hammer and 1/8 inch punch, drive pin (D) all the way in hole.
8.
Position bracket (B) in vehicle.
9.
NOTE
It may be necessary to tap lever (F) with
hammer for installation.
Install washer (E) and lever (F) on shaft (A).
10.
Using wrench, install two screws (G), lockwashers (H), and flat washers (J) attaching
11.
bracket (B).
12.
Using 1/8 inch punch, line up hole in shaft (A) with hole in lever (F).
Using pliers, start pin (K) in hole in lever (F).
13.
14.
Using hammer and 1/8 inch punch, drive pin (K) all the way in hole.
Install clevis pin (L) through hole in clevis (M) and hole in lever (F).
15.
16.
Install cotter pin (N) in clevis pin (L).
Operate rear drain valve and make sure valve opens and closes smoothly. If valve does
17.
not open and close properly, check for debris in the way and for missing parts. Clear
debris in the way and install missing parts.
End of Task
TA248558
17-27