TM 5-5420-202-20-4
REAR DRAIN VALVE REAR ROD, COUPLING, AND CLEVIS REPLACEMENT
(Sheet 5 of 6)
4.
Put end of rod (C) through hole in bracket (D).
5.
Install coupling (E) and coupling jamnut (F)
on end of rod (C).
6.
Adjust coupling (E) and coupling jamnut (F)
until original length of threads can be measured
on rod (C) with coupling jamnut (F) finger
tight ened against coupling (E) (page 17-30,
step 5).
7.
Using 9/16 inch wrench, tighten coupling
jamnut (F) against coupling (E) while holding
coupling (E) with another wrench.
8.
Line up coupling (E) with rear intermediate
control rod (G).
Go on to Sheet 6
TA248563
17-32