TM 5-5420-202-34
ENGINE REPLACEMENT
Power Takeoff Installation On Replacement Engine (Sheet 3 of 11)
Place check valve mounting bracket
(F) in position on studs (G) as shown.
Untapped holes of bracket (F) go over
studs (G).
Using 9/16 inch socket, install two washers
(H) and two nuts (J) to secure bracket
(F) to studs (G) on engine housing.
8.
Place clamp (K) over plastic fuel line
(L).
Attach clamp (K) and plastic fuel line
9.
(L) to check valve (M) using screw (N)
and two washers (P). Insert screw through
top mounting hole of valve (M).
10.
Insert screw (N) and washer (P) through
lower mounting hole of check valve (M).
11.
Using 7/16 inch socket, tighten two
screws (N) securing check valve (M) to
bracket (F).
Go on to Sheet 4
3-41
