TM 5-5420-202-34
ENGINE REPLACEMENT
Power Takeoff Installation On Replacement Engine (Sheet 5 of 11)
13.
Place gasket (S) in position over mounting
studs (D) on engine housing.
14.
Place power takeoff (T) in position on
engine mounting studs (D). Power takeoff
must be positioned so fuel pump (U) is
at approximately eight o'clock position.
15.
Carefully guide power takeoff short
splined input shaft (V) into hole in adapter
(A).
NOTE
Do not install the topmost washer
(W) and nut (X) on stud (D).
16.
Using 9/16 inch socket, secure power
takeoff (T) with washers (W) and nuts (X).
Go on to Sheet 6
3-43
