TM 5-5420-202-34
ENGINE REPLACEMENT
Replacement Engine Installation (Sheet 11 of 17)
8.
Push transmission input shaft (L) into
transmission. If engine and transmission
splines do not aline, use 5/8 inch socket
to remove six power takeoff cover screws
(M) and lockwashers (N). Remove cover
(P) and gasket (Q). Throw gasket (Q)
away.
9. Using pinion turning wrench. turn transmission
until splines aline and shaft (L) will slide in and
seat properly.
10.
Remove pinion turning wrench.
11.
Using retaining ring pliers, install retaining
ring (R) on input shaft (L).
12.
Position gasket (S) onto plug (T), and
using 1-1/8 inch socket and torque wrench,
tighten plug (T) to 50-60 lb-ft (68-81 N . m).
13.
Position new power takeoff gasket (Q)
and cover (P) on transmission housing
and using 5/8 inch socket, install six
screws (M) and washers (N).
Go on to Sheet 12
Change 2
3-67
