TM 5-5420-202-34
ENGINE REPLACEMENT
Replacement Engine Installation (Sheet 7 of 17)
25.
Using 1-1/8 inch wrench, remove input
shaft plug (AR) and gasket (AS) from
transmission.
CAUTION
It may be necessary to place finger
through retaining ring (AT) to make
sure that it does not fall into
transmission housing during
removal.
26.
Using retaining ring pliers, remove retaining
ring (AT) at rear of input shaft (AU).
27.
Using puller and adapter, draw the input
shaft (AU) rearward until it is disengaged
from the engine drive connection.
28.
Attach lifting sling to transmission lifting eyes. Using a suitable hoist, take up slack until
sling supports weight of transmission without lifting powerplant from blocks.
29.
Place a pan under engine and transmission at separation point to catch oil.
Go on to Sheet 8
3-63
