TM 5-5420-202-34
FUEL PRIMER PUMP REPAIR (Sheet 3 of 6)
4.
Place handle assembly in vise with vise
head between points (J) as shown in picture.
5.
Slide two connector shells (K) back on
leads and remove two slotted washers
(L).
6.
Remove connector shells (K) by sliding
down and off.
7.
Using 1-1/8 inch wrench, remove nut
(M) and lockwasher (N) from operating
handle (P).
8.
Remove operating handle (P) from lever
(Q).
Remove lever (Q) from vise and set aside.
9.
10.
Using screwdriver, remove screw (R)
and lockwasher (S) from handle (T).
11.
Remove handle (T), upper sleeve (U)
and plunger (V).
12.
Remove lower sleeve (W) from switch
assembly (X).
Go on to Sheet 4
4-79