TM 5-5420-202-34
FUEL PRIMER PUMP REPAIR (Sheet 5 of 6)
ASSEMBLY:
1.
Using 9/16 inch wrench, install two inlet
valves and new preformed packings (A)
and two outlet valves and new preformed
packings (B) in primer pump (C).
2.
Install new lockwire (Item 26, Appendix
(A and B)..
3.
Install rod assembly (E) in primer pump
(C).
Using 1-1/2 inch wrench, install and
4.
tighten gland (F) of rod assembly (E) into
primer pump (C).
5.
Install new lockwire (G) through holes (H)
securing rod assembly (E) to primer
pump (C).
Install lower sleeve (J) on switch assembly
6.
(K).
Place plunger (L) over switch assembly
7.
(K).
Place flat end of upper sleeve (M) over
8.
switch assembly (K).
Place handle (N) over assemblies (J, K,
9.
L, M) and aline holes in handle (N) and
lower sleeve (J).
10.
Using screwdriver, install screw (P) and
lockwasher (Q).
Go on to Sheet 6
