TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 11 of 13)
NOTE
in housing (V) with vise.
15. Slide short lever (W) onto shaft (X).
Line up pin holes.
16. Insert pin (Y) into lever (W).
17.
Using hammer and pin punch, install pin (Y) into lever (W) and shaft (X).
18.
Install shaft (X), lever (W), and pin (Y) into riser housing (V) as an assembly.
19.
Install long lever (Z) onto shaft (X) until lever and shaft pin holes line up.
20.
Insert pin (AA) into long lever (Z).
21.
Using hammer and pin punch, install pin (AA) into long lever (Z) and shaft (X).
Go on to Sheet 12
4-109