TM 5-5420-202-34
BULKHEAD CABLE DISCONNECT (Sheet 1 of 2)
9/16 in. socket with 1/2 in. drive
TOOLS:
Spanner wrench
Ratchet with 1/2 in. drive
Flat-tip screwdriver
Gaskets (4 required)
Lockwashers (11 required)
SUPPLIES:
TM 5-5420-202-20
REFERENCE:
three ground straps from battery negative ter-
Remove
PRELIMINARY PROCEDURES:
(TM 5-5420-202-20)
minals
Remove
commander's seat (TM 5-5420-202-20)
right bulkhead access cover (TM 5-5420-202-20)
Remove
REMOVAL:
1.
Using 9/16 inch socket, remove seven
screws (A) and lockwashers (B) securing
connector cover plate (C) to bulkhead.
2.
Pull connector plate cover (C) and its
gasket (D) away from bulkhead. Harness
assemblies inside bulkhead will come
with cover plate (C).
NOTE
To remove either of the two middle
connectors on the cover plate, you
must first remove either the top or
bottom connector, as required, to
get a spanner wrench on the desired
connector.
3.
Using spanner wrench, disconnect and
remove connector (E) at back side of
cover plate (C).
Using flat-tip screwdriver, remove four
4.
screws (F) and lockwashers (G) securing
corresponding connector (H) and gasket
(J) at front side of cover plate (C).
Go on to Sheet 2
