TM 5-5420-202-34
FRONT ACCESSORY HARNESS REPLACEMENT (Sheet 7 of 14)
30.
Using 7/16 inch socket, remove screw (BL), clamp (BM),
and lockwasher (BN) from between IR power packs (BP)
and (BQ).
31.
Using 7/8 inch wrench, loosen and disconnect connectors
(BR) and (BS) from IR powerpacks (BP) and (BQ).
3 2 . Follow wiring harness
assembly (D) to reverse
polarity protection
device (BT) which
is attached to master
power relay (BU) adjacent
to voltage regulator
(AW).
33. Using adjustable wrench, hold
flange (BV) of reverse polarity
device while using 7/8 inch wrench
to disconnect connector (BW)
from reverse polarity protection
device (BT).
34.
Using spanner wrench, loosen spanner
nuts (BX) and disconnect connectors
(BY) from voltage regulator (AW).
35.
Disconnect two bulkhead connectors
(BZ) (page 5-2). Remove wiring harness
assembly (D) from vehicle.
Go on to Sheet 8
5-89
