TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 20 of 23)
NOTE
The procedure described in step 50 ap-
plies to the right and left side exhaust
pipes.
Position gasket (BC) and exhaust pipe (BD)
50.
onto turbocharger (BE) and, using 1/2 inch
socket, install six nuts (BF) securing exhaust
pipe to turbocharger.
51.
Install clamps (BG) onto engine breather
tube and position tube onto engine and exhaust
mounts. Using screwdriver, tighten clamps
(BG) securing tube (BH) to mounts.
Using adjustable wrench, install elbow (BJ)
52.
onto transmission.
Position transmission vent line (BK) onto
53.
transmission and connect nut (BL) to elbow
(BJ).
53.1. If transmission is mated to a 2DA engine,
connect transmission vent line elbow (BM)
to nut (BM.1). Using 3/4 inch wrench, tighten
transmission vent line nut (BM.1) to elbow
(BM). Using 7/8 inch wrench, tighten trans-
mission vent line nut (BL) to elbow (BJ).
5 3 . 2 . If transmission is mated to a 2D engine,
connect transmission vent line nut (BM.2)
to elbow (BM.3). Using a 7/8 inch wrench,
tighten transmission vent line nuts (BL
and BM.2) to elbows (BJ and BM.3).
Go on to Sheet 21
6-38
Change 1
