TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 17 of 23)
NOTE
A d a p t e r (AG) must be positioned
properly. Left side adapter has hole for
thermostatic switch which is angled
downward
Right side adapter has
threaded hole of oil temperature sensor
angled upward.
On right side of transmission position
33.
gasket (AF) and adapter (AG) on studs.
34.
Using 9/16 inch socket,
install six nuts (AH) on studs.
35.
On left side of transmission, position
gasket (AF) and adapter (AG) onto studs.
36.
Using 9/16 inch socket, install four
nuts (AH) onto studs. Do not install
nuts on two studs located at top of
adapter (AG) on left side.
NOTE
The procedures described in steps
37 and 38 apply to the left and right
side of transmission.
37.
Position metallic gaskets (AJ) onto adapter (AK) and, using 1-5/8 inch wrench, install
adapters (AK) onto adapters (AG).
Using 1-1/2 inch wrench, install tubes (AL) onto adapters (AK).
38.
Go on to Sheet 18
6-35