TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 22 of 23)
Position bracket (CD) onto stud and,
60.
using 9/16 inch wrench, install nut and
washer (CE) onto stud.
61.
Using pliers, install new cotter pin (CF)
through stud.
62.
Using two 9/16 inch wrenches, tighten
screw (CG) and nut (CH).
Install two washers (CJ), two nuts (CK),
63.
and stud (CL) onto transmission.
64.
Install stud (CL) far enough back into
transmission to be able to install bracket
(CM).
Position bracket (CM) and rod (CN) onto
65.
transmission as a unit.
66.
Using 3/4 inch socket, install two washers (CP) and nuts (CQ) securing bracket to
transmission.
Adjust stud (CL) to permit installation of washer (CR) and nut (CS). Using 3/4 inch
67.
socket, install washer (CR) and nut (CS).
Using 3/4 inch socket and wrench, tighten nuts (CK) up against transmission and bracket.
68.
Go on to Sheet 23
6-40