TM 5-5420-202-34
STEERING CONTROL SLEEVE ASSEMBLY REPLACEMENT AND REPAIR (Sheet 2 of 4)
3.
Using 9/16 inch wrench, remove nut (D)
from bulkhead shaft (E).
4.
Using 7/16 inch wrench, remove two
jamnuts (F).
5.
Using 1/8 inch hex wrench, remove two
setscrews (G).
6.
Slide sleeve assembly (H) toward front
of vehicle and off shaft (E).
DISASSEMBLY:
1.
Using 5/16 inch wrench, remove grease fitting (A) from sleeve (B).
2.
Position sleeve (B) in vise. Using hammer and bearing installation and removal tool,
remove two seals (C) and bearing (D) from sleeve (B). Throw seals (C) and bearing (D)
away.
Go on to Sheet 3
10-4
