TM 5-5420-203-14
c. Assembly of the Bridge Separated into Eight Sections - CONT
(2) Installation of Near Shore Diaphragm.
(a) Using three bolts (1). attach one end of
diaphragm (2) (pintle hole facing toward
ramp end) to clip angle of bridge section
(3). Thread three nuts (4) on bolts (1).
Position nuts (4) midway between holes on
bolts (1). Install three retainers (5) (one
each) in hole in threaded end of each bolt
(1).
( b ) Position the clip angle of second ramp
section (6) to align with diaphragm (2).
(c) Using three bolts (1), attach other end of
diaphragm (2) to clip angle of second ramp
section (6). Thread three nuts (4) on bolts
(1). Position nuts (4) midway between
holes on bolts (1). Install three retainers (5)
(one each) in hole in threaded end of each
bolt (1).
(3) Installation of Cylinder Beam.
NOTE
The cylinder beam pivot mount must point
toward the center sections of the bridge.
(a) Position cylinder beam (1) on clip angles
of ramp section (2). Install three bolts (3)
through clip angle and cylinder beam.
Secure one end of cylinder beam by
threading three nuts (4) on three bolts (3).
Position nuts (4) midway between holes on
bolts (3). Install three retainers (5) (one
each) in hole in threaded end of each bolt
(3).
(b) Position the clip angle of second ramp
section (6) to align with the cylinder beam
(1).
(c) Install three bolts (3) through clip angle
and cylinder beam. Thread three nuts (4)
on three bolts (3). Position nuts (4)
midway between holes on bolts (3). Install
three retainers (5) (one each) in hole in
threaded end of each bolt (3).
Change 2 2-15
