TM 5-5420-203-14
c. Assembly of the Bridge Separated into Eight Sections - CONT
(12) Installation of Far-Shore Center Sections Flexible Hydraulic Hoses.
Do not raise sections off the ground
to hookup hydraulic connections.
The section could fall causing serious
injury or death.
(a)
Install one 10 ft flexible hydraulic hose
(1) through the hose guides (2) located
on center section (3). Connect the
flexible hose as shown. Be sure hose
is tight.
Connect the other end of the flexible
(b)
hydraulic hose (1) to the assembled
HOSE GUIDE
near-shore half of the bridge (4).
HIDDEN
NOTE: View is from underneath looking up.
(c)
Repeat steps (a) and (b) for other
center section (not shown).
(13) Installation of Locking Pins, Lubricated Center Section, and Quadrant Hinge Pins.
SECTION LOCKING
QUADRANT
QUADRANT
AND CONNECTING PIN
HINGE PIN
LOCKING PIN
Use care when pinning sections. Sections are heavy and can cause injury to personnel.
(a) Position the two far-shore center sections next to the assembled near-shore half. Aline the
male and female hinges.
2-20
