TM 5-5420-203-14
HYDRAULIC CYLINDER REPLACEMENT (Sheet 2 of 3)
Disconnect hydraulic cylinder hydraulic line
c*
(9) from connecting point (10) located on center
section (11). Disconnect other end of line (9)
from connecting point (12) located on hydraulic
cylinder (5).
d. Disconnect hydraulic cylinder hydraulic line
(13) from connecting point (14) located on
center section (15). Disconnect other end of
line (13) from connecting point (16) located on
hydraulic cylinder (5).
e. Remove two bolts (17) securing upper
hydraulic cylinder support (18) to center
sections (11 and 15). Remove support (18).
f. Remove four bolts and slide transverse brace
(19) over cylinder cap end (20). Refer to
The hydraulic cylinder and pins are heavy.
They could slip and fall and crush hands or
feet. Stay clear of cylinder, pins, etc.
g. Attach a lifting sling (21) to hydraulic cylinder
upper bracket assembly (22). Take up the slack
in the cable using lifting device.
h. Remove one cotter pin (23) from hydraulic
cylinder pin (24). Remove pin (24) releasing
hydraulic cylinder (5) from cylinder beam (25).
i. Using lifting device, lift hydraulic cylinder (5)
-
from center sections and set aside.
INSTALLATION
INSTALL HYDRAULIC CYLINDER (5).
a. Attach lifting sling (21 ) to hydraulic cylinder
upper bracket assembly (22).
b. Swing hydraulic cylinder into position
between center sections (11 ) and (15) as shown.
3-24