TM 5-5420-203-14
HYDRAULIC CYLINDER REPLACEMENT (Sheet 3 of 3)
Aline cap end (20) of hydraulic cylinder (5)
with flange (26) of cylinder beam (25). Install
hydraulic cylinder pin (24) securing cylinder
(5) to cylinder beam (25). Install cotter pin (23)
in pin (24).
Position hydraulic cylinder support (18) in
position in clip angles of center sections (11)
and (15). Install two bolts (17) in support (18)
Tighten two bolts (17).
Position bottom and top flanges of equalizer
plate (1) over rod end (4) of hydraulic
cylinder (5). Aline holes in both.
Insert equalizer plate pin (3) in equalizer plate
(1) and through rod end (4).
Install cotter key (2) in pin (3).
WARNING
FRH hydraulic fluid may contain
Tricresyl Phosphate (TCP) which, if
taken internally, can cause paralysis.
Hydraulic fluid may be absorbed through
the skin. If hydraulic fluid gets on skin,
wash with soap and water as soon as
possible.
Connect hydraulic cylinder hydraulic line
(9) to connection point (10) located on
center section (11). Connect other end of
line (9) to connecting point (12) located on
hydraulic cylinder (5).
Connect hydraulic cylinder hydraulic line
(13) to connection point (14) located on center
section (15). Connect other end of line (13) to
connecting point (16) located on hydraulic
cylinder (5).
Be sure manual hydraulic bleed valves (6) and
(7) located under protective housings (8) on
hydraulic cylinder (5) are closed.
END OF TASK
3-25
