TM 5-5420-203-14
CYLINDER BEAM REPLACEMENT
General Mechanics Tool Box SC 5180-90-N26
TOOLS/EQUIPMENT
None
SUPPLIES:
Scissoring Cables and attaching hardware removed (pg 3-20).
EQUIPMENT CONDITIONS:
Hydraulic Cylinder removed (pg 3-23).
Ramp Section Lateral Brace removed (pg 3-34).
Near-Shore Ramp Section Transverse Braces removed (pg 3-35).
Quadrant removed (pg 3-43).
Near-Shore Ramp Section removed (pg 3-46).
Two
PERSONNEL:
REMOVAL
REMOVE CYLINDER BEAM (4).
a. Remove six bolt retainers (1) from
bolts (2)
b. Remove six nuts (3) from bolts (2)
securing cylinder beam (4) to clip
angles of ramp sections (5 and 6).
c. Remove cylinder beam (4) from
ramp sections (5 and 6).
INSTALLATION
INSTALL CYLINDER BEAM (4).
a. Position cylinder beam (4) on clip
angles of ramp sections (5 and 6) and
aline bolt holes.
b. Install six bolts (2) securing cylinder
beam (4) to clip angles of ramp
sections (5 and 6).
c. Thread six nuts (3) on bolts (2).
d. Install six retainers (1) on bolts (2)0
END OF TASK
3-31
