TM 5-5420-203-14
RAMP SECTION MISCELLANEOUS COMPONENTS REPLACEMENT (Sheet 1 of 2)
General Mechanics Tool Box SC 5180-90-N26
TOOLS/EQUIPMENT:
Lock Washer (item 2, Appendix E) (three required).
SUPPLIES:
Lock Washer (item 3, Appendix E) (two required).
Lock Washer (item 4, Appendix E) (two required).
Tie Rods removed (pg 3-13).
EQUIPMENT CONDITIONS:
Scissoring Cables and attaching hardware removed (pg 3-20).
Hydraulic Cylinder removed (pg 3-23).
Cylinder Beam removed (pg 3-3 1).
Flexible Hydraulic Lines (diaphragm) removed (pg 3-32).
Lateral Brace removed (pg 3-34).
Transverse Brace removed (pg 3-35).
Diaphragm removed (pg 3-5 1).
Ramp Section deck extrusion removed (pg 3-52).
Five
PERSONNEL:
REMOVAL
REMOVE RAMP SECTION MISCELLANEOUS COMPONENTS.
a. Remove two nuts (1) and two lock washers (2) from two screws (3) holding pipe anchor clamp
(4) to angle bracket (5) (not shown). Remove two flat washers (6) from screws (3). Discard
lock washers.
b. Remove nut (7) and lock washer (8) from
screw (9). Remove spring tension clip (10).
Remove flat washer (11) and screw (9) from
ramp section (12). Discard lock washer.
c. Remove two nuts (13), two lock
washers (14), and two flat washers
(15) from two machine screws (16).
Remove two machine screws
(16). Remove pipe flange (17).
Discard lock washers.
d. Remove two nuts (18) and
two lock washers (19) from
two screws (20). Remove
two screws (20). Remove
lifting bar (2 1). Discard
lock washers.
e. Remove threaded
screw insert (22)
from ramp section (12).
3-58
