TM 5-5420-209-12
Figure 2-30. Bay Water Recovery (Sheet 1 of 5).
NOTE
Rear support of transporter must be kept parallel to surface of water. If the rear support is not, recovery
is only possible with assistance from bridge boat.
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Back transponder into water until rear wheels are hub deep.
Set parking brake and electric brake and place transporter in neutral.
Engage PTO.
Remove quick release pin (2) and install in holder (3).
Retract (pin out) locking cylinder pin (4).
Ensure cable (5) is properly routed around boom sheave (6).
Raise boom (7) to full aft position and pay out cable until hook (8) is approximately 1-2 ft
(.3 -.6 m) below surface of water.
2-102
