ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
(3)
CENTER BRACKET. For connection of rear end of light launching nose, launching nose roller, and push bar.
Components are connected to this bracket with a launching nose pin.
(4)
RAMP SHELF For connection of ramp units to bankseat beam, for connection of jacking bracket links when using
davit posts and for connection of launching nose roller.
(5)
ANTI-LIFT LUGS. Prevents ramps from lifting off bankseat beam.
(6)
IDENTIFICATION PLATE. The component serial number is marked on this plate.
CAUTION
DO NOT hammer on shoot bolts, panel or nose pins being inserted in bank- seat beam. Damage to
components may result.
(3)
Ramp Unit Short and Long
The ramp unit is used at each end of the bridge and allows vehicles easy access and exit. Seven units are
connected to each end. Short ramps are used on single story bridges only. Long ramps can be used on single story
bridges, but must always be used on double story bridges. Short ramps are carried by four personnel. Long ramps are
carried by four or six personnel.
BANKSEAT BEAM
1-17