TM 5-5420-226-20-2
SERVICE DUST DETECTOR FILTER STRIP (Sheet 1 of 2)
SUPPLIES:
Pipe cleaner (Item 67, Appendix D)
Tubing, non-metallic (Item 70, Appendix D)
Wire, 0.030 inch diameter (Item 63, Appendix D)
Cloth (Item 12, Appendix D)
Dry cleaning solvent (Item 55, Appendix D)
Goggles (Item 71, Appendix D)
Rubber gloves (Item 72, Appendix D)
PRELIMINARY
PROCEDURE:
Remove dust detector filter strip and cover (page 7-116.11)
SERVICE:
WARNING
Dry Cleaning Solvent P-D-680 is
To avoid
toxic and flammable.
injury, wear protective goggles and
gloves and use in a well-ventilated
area
Avoid contact with skin,
e y e s , and clothes, and do not
breathe vapors. Do not use near
open fire or excessive heat. The
flash point for Type I Dry Cleaning
Solvent is 100F (38C), and for
Type II is 138F (50C). If you
become dizzy while using Dry
Cleaning Solvent, get fresh air
immediately and get medical aid.
If contact with eyes is made, wash
y o u r eyes with water and get
medical aid immediately.
1.
Using clean cloth dampened with cleaning
solvent, clean cover (A) and mount-
ing face of compressor housing (B).
Inspect compressor housing chamber (C)
2.
for contamination. Clean chamber (C) as
required.
3.
Using pipe cleaner, clean compressor
housing orifice chamber (C). Use wire
to clean orifice (D). Blow out chamber
(C) and orifice (D) by mouth, using a short
piece of tubing.
Go on to Sheet 2
Change 2