TM 5-5420-226-20-2
RIGHT FUEL TANK FILLER REPAIR (Sheet 5 of 6)
INSTALLATION:
1.
Install strainer (A) in fuel tank (B).
2.
Install filler neck (C) on fuel tank (B).
3.
Using allen wrench, secure filler
neck (C) to fuel tank (B) using
eight screws (D).
4.
If required, use slip joint pliers
and install lockwire (E) in eight
screws (D).
5.
Using two new gaskets (F) and
(G), assemble seal assembly (H)
and tighten screws (J) finger tight.
6.
Install seal assembly (H) on filler
neck and, while holding filler neck
in position, tighten screws (J)
until gaskets (F) and (G) are compressed
to form tight seal between filler
neck and hull.
Go on to Sheet 6
TA107729