TM 5-5420-226-20-2
FUEL TANKS (LEFT AND RIGHT) LEVEL GAGE TRANSMITTER REPLACEMENT (Sheet 2 of 4)
NOTE
Steps 1, 2, and 3 only apply to the right fuel
gage transmitter.
Using 1/2 inch socket, remove
1.
three bolts (A), lockwashers (B),
and two flat washers (C) securing
bracket (D), safety chain (E),
and cover (F) to fuel tank.
Using 7/16 inch open end wrench
2.
to hold nut (G), use 7/16 inch
socket to remove screw (H), lock-
washer (J), and nut (G) securing
clamp (K) to bracket (D).
Remove bracket (D) and cover (F).
3.
Disconnect electrical lead (L) from trans-
4.
mitter (M).
Using pliers, cut and remove lockwire (N).
5.
6.
Using screwdriver, remove five screws
and washers (P) securing transmitter (M)
to fuel tank.
Carefully lift transmitter (M) out of fuel
7.
tank until float arm gears (Q) are visible
in fuel tank opening (R).
Reach in with finger and pull up on
8.
visible tip of float arm. Pull trans-
mitter (M) out of tank opening (R)
until float appears.
TA107734
Go on to Sheet 3
7-129