TM 5-5420-226-20-2
FUEL INLET FLUID PRESSURE FILTER REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
NOTE
Apply sealing compound to all male
threaded ends before making con-
nections.
Using 1/2 inch wrench, install
1.
adapters (A) and (B) into filter (C).
2.
Using screwdriver, install filter (C)
to hull with two screws (D) and
lockwashers (E).
Place ends of tube assemblies (F)
3.
and (G) on adapters (A) and (B).
Slide fuel line nuts (H) and (J) onto
adapters (A) and (B) and tighten
finger tight.
4.
Using 1/2 inch wrench on adapters
(A) and (B) and 9/16 inch wrench on
fuel line nuts (H) and (J), tighten
fuel line nuts (H) and (J).
5.
Open shutoff cock (K).
6.
Start engine and check each connec-
tion of fuel lines for leaks.
7.
Remove and dispose of rags safely.
TA107859
End of Task