TM 5-5420-226-20-2
TM 5-5420-202-34
FUEL TANKS (LEFT AND RIGHT) UPPER FRONT MOUNT REPLACEMENT
(Sheet 3 of 6)
9.
Using 9/16 inch wrench to hold screws (N) and 9/16 inch socket and ratchet to
loosen nuts (P), remove three nuts (P), discard star washers (Q), and screws (N) securing
plate (R) at corner bulkhead opening.
10.
Remove mounting plate (R).
CLEANING AND INSPECTION:
Clean rubber mounts with detergent and warm water.
1.
Dry cleaning solvent P-D-680 is toxic and flammable. To prevent personal
injury, wear protective goggles and gloves and use only in a well-ventilated
area. Avoid contact with skin, eyes, and clothes and don't breathe vapors.
Do not use near open flame or excessive heat. The flash point for Type #1
Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C). If you
become dizzy while using cleaning solvent, get fresh air immediately and get
medical aid. If contact with eyes is made, wash your eyes with water and get
medical aid immediately.
Clean metal parts with dry cleaning solvent. Using rag, wipe parts dry.
2.
Inspect mounts for cuts or wear.
3.
Inspect metal parts for damage, wear, or stripped threads.
4.
5.
Replace unserviceable parts.
4-68