TM 5-5420-226-20-3
MASTER CONTROL PANEL REPAIR (Sheet 60 of 73)
Master Battery Wiring Harness Replacement (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS:
Flat-tip screwdriver
11/32 in. wrench open end
7/16 in combination box and open end wrench
SUPPLIES: Silicone compound (Item 32, Appendix D)
PRELIMINARY PROCEDURE: Remove panel from vehicle (page 10-34).
REMOVAL:
1.
Using flat-tip screwdriver on screw (A)
and 11/32 inch wrench on nut (B), remove
four screws (A), lockwashers (C), and
nuts (B) securing connector (D) to panel
(E).
2.
Remove connector (D) from panel and
position aside.
Using flat-tip screwdriver on screw (F)
3.
and 11/32 inch wrench on nut (G), remove
four screws (F), lockwashers (H), and
nuts (G) securing connector (J) to panel
(E).
4.
Remove connector (J) from panel and
posit ion aside.
Go on to Sheet 2
TA168748
